Home > Diving Equipment > Full Face Masks > Full Face Masks Parts >

ScubaPro HUD Mount for OTS Guardian Full Face Mask

ScubaPro HUD Mount for OTS Guardian Full Face Mask


 
Our Price: $75.00
Vendor: Scubapro



Availability: Usually Ships in 7 to 10 Business Days
Product Code: 24.501.000
Qty:

Description
 
SCUBAPRO’s OTS Guardian/Stealth HUD mount allows you to mount the Galileo HUD to the OTS Guardian Full Face mask. This gives Public Safety Divers the ability to use the Galileo HUD in low visibility diving.

There are two ways you can attach the SCUBAPRO HUD mount to the OTS FFM. Before you do anything, make sure the set screw on the back of the HUD mount is backed off so it will not scratch the mask lens frame. It will also make it easier to install the mount. The first way is to put it on the left or right side (Blue arrows below) of the mask frame where the lip of the frame is smaller.

Hook the back lip of the HUD mount to the inside lens frame and slowly push the HUD mount down onto the mask it should just pop on and then slide it towards the middle, so you have the best view of the HUD screen. The other way is to gently hook the back lip of the mount to the inside lip of the lens frame and then slowly snap the front lip in place. Once it in place, so you have the best view of the HUD screen, you can now snug (DO NOT OVER-TIGHTEN IT) the set screw in place, and this is done with a – Allen wrench.

On the OTS Guardian and Stealth masks. Put the mount on frame, have the screws a little loss so you can set the proper eye relief and sight picture. Once this is done you can tighten the screws making sure not to over tighten. MAKE SURE YOU ALWAYS USE THE SAFETY lanyard, so you do not loss you HUD. For Interspiro masks remove the center plate/spacer and follow the above procedure. Lastly make sure you have three washers on the inside of the spring, this will allow for full range of motion (up and down) for the HUD.

Share your knowledge of this product with other customers... Be the first to write a review