 |
When you need to float an object close to the surface, use SUBSALVE's "pillow" shaped Enclosed Flotation Bags in any position - upright or flat, outside or inside of structures - for vessel salvage, auto recovery, pipeline and cable installation and emergency flotation for ships, aircraft, submersibles and ROVs.
Adaptive:
-
Configure a multitude of rigging combinations.
-
Use with a single pick point (shackle supplied on the bottom of the bag).
-
Invert to use the multiple stainless steel rings on the top of the bag.
Fabric:
-
Urethane-coated nylon - high-strength and heavy-duty
-
Superior abrasion resistance
-
Resistant to most petro-chemicals
-
UV-resistant
-
Low maintenance requirements and easy to clean
-
RF welded seams
Lifting Harness:
-
Heavy nylon lift harness built into the body of the lift bag
-
Safe working ratio of 6:1
Safe and easy to use:
-
Equipped with all necessary hardware - ready for immediate use
-
3/4" NPT inflation/deflation port equipped with ball valve
-
Stainless steel quick disconnect for inflation
-
Pressure relief valves: set to release at 2.5 psi above ambient pressure
-
Enough pressure relief vales are installed in each bag to allow expanding to vent should a free ascent occur.
Each SUBSALVE USA lift bag is tested prior to shipping.
Custom sizes available.
All Subsalve USA products are compliant with IMCA D-016-AIRBAGS, ABS, U.S. Department of Defense Standards.
|
|
|
Lame Pics, didn't get what I wanted 
